Gas Dryer wont heat
Dryer not heating? If your old or new front or top loading dryer is all of a sudden not drying your clothes, then we have a few simple DIY fix tips you can try yourself. If the dryer is no longer drying your clothes then the first thing to do is to check and clean the dryer lint filter trap. We were forced to add that as our first step as there really are some people who do not realize there is a LINT FILTER that must be cleaned before or after each use. Once that is cleaned out, check if the dryer is still NOT drying your clothes. If that was NOT the cause of the problem, then you will need to inspect the vent hose on the back of the dryer. Commonly this HOT AIR VENT HOSE will become clogged, caked or full of lint that is constantly being removed from your clothing when drying. When this happens your dryer is unable to expel the hot air from within, therefore making it impossible for your dryer to actually dry your clothing in a timely manner or at all.
The most common causes for an electric or gas dryer to stop drying or heating is:
1. The dryer lint screen (lint trap) has not been cleaned (poor or restricted airflow).
2. A clogged or kinked (bent) dryer air vent hose (inadequate or no airflow).
3. Drum has stopped turning, broken drum drive belt.
4. Overheated or bad motor (possible thermal overload).
5. Thermal fuse or thermostat (could be caused from dryer air vent hose lint buildup)
6. Heating element burnt out.
7. Loose electrical plug or power socket.
8. Other mechanical issue, fault or malfunction.
If your clothes dryer is taking forever to dry your clothes or it is not drying your clothing at all (and you already thoroughly cleaned the lint filter screen), then the first step is to CLEAN OUT THE INSIDE OF THE DRYER VENT HOSE. First, unplug your dryer from the electrical socket on the wall. Slide the dryer forward very carefully so you can get behind it. Locate the (usually silver colored) air vent hose, and remove it from the wall and the dryer (2 connection points). Do this by squeezing the clip at both ends and pulling the hose outward. Using a long dryer vent brush or similar, clean out the inside of the air vent hose by removing all of the built up lint and dust looking material. Clean the area on the back of the dryer and the hole in the wall where the air is vented out. Most of the time the lint will be built up in both of these areas. Once all of the lint is cleaned out, reattach the vent hose and slide the dryer back in place. Make sure you DO NOT KINK the vent hose when repositioning the dryer as this will cause the dryer to NOT expel the hot air properly. If you kink the hose the dryer will not function properly and your clothes will take forever to dry. Next, plug the dryer back into the power outlet and run a test. If your dryer is now heating and properly drying your clothes then you fixed the problem. If not, read on…See also:
DE363 GAS DRYER IGNITOR REPAIR PART FOR WHIRLPOOL, AMANA, MAYTAG, KENMORE AND MORE
Major Appliances (ERP)
Home | Yahoo Answers
Here is a tip that will help you with your problem..
believe it or not it is not an electrical problem, but an ignitor problem...